Hmmm.. I have so many parts for an mcpx version 2... even alloy heads etc. Let me see what i can find. I might have enough for a complete build and even more.

 

Sounds good look forward to your reply

 

Hi @Servo. Sorry dont have a complete unit, short on the servos and frame (lots of broken frames) However i do have : 4 motors, about 5 sets of blades, alloy head, 3 main boards, a couple of brand new feathershafts and tail. If your interested i will take a photo for you.

 

Yes definitely interested yes please

 

Hi @Servo... 3 working main boards, one with a brushless conversion kit in it (which really rocks), another 3 main boards with faulty FETS which you can change if you need to (three boards will last a while) I also have the FETS to repair if you need to make the other boards work. Here is a new main board of the same type shown here(http://www.ebay.com/itm/BLADE-mCPX-...-RX-ESCs-Gyros-mCP-X-V2-BLH3601-/131192269122). Heaps of blades though most are used however you would get working sets out of them i am sure. Metal swash plate and metal head, feather shafts (not shown) a few new parts like landing gear and tail and even an extreme carbon frame which othe tail section changed (included in the new parts). It would need the canopy pegs if you want to use the extreme frame which is only 1.5mm carbon rod i think - but i found the stock frames just as good for the V2 so i personally would stick with that. So there is a bit you can use for sure. If you are interested make an offer...Like i said, not a complete unit but you could make one up and have lots of spares i am sure.

 

I see that 120SR tail blade.

 

The 120SR tail blade was used with the brushless mod. It gave superior tail authority compared to the standard motor. The brushless mod is pretty crazy but battery life is reduced as a result...

 

Geena all i am really looking for is a standard board that works.
I cannot understand from your message weather any of the boards fully work or not.
I have servos and frame..I need a board and maybe the metal swash?And a tail standard is fine?,Bearing and a main motor.
Really just a standard mcpx.
Hope you can help.

 

Hi @Servo, 5 boards in total, 3 boards are working, the other two have a blown FET. Metal swash is good and tail is new. If you want, PM me an offer...

 

I sent you a Pm but no reply.?

 

Oh sorry servo i must have missed it..... Hangon let me check...

 

I have 2 brand new never opened Blade mCPX choppers. Through a mix up with an order I bought 4 of them. I fly 2 and 2 remain pristine in never opened boxes. Let me know if you are interested. They are mode 1, BNF.
Adrian

 

Send me a pm Adrian with a price please.

 

Servo,

(Whats a pm?) Anyway, the crux is what price are you willing to pay , for 1 or both, plus postage. Again I assure you these have been sitting in my cupboard living a lazy life. 0.0 k's on the clock. Never unboxed.

 

Private message dude.pm me