Frequency analysis of the audio track shows 2921 rpm at full charge dropping about 100 rpm at hard pitch. Running the numbers through an app puts...
If I were planning to keep the camera on permanent, those options would work out great. It's intended for occasional use.
Good suggestions there. I was thinking about using a 200mAh 1s LiPo and a dropping resistor. Simple, self contained, and portable so I can use the...
Yeah, that would rank right up there with knife throwing around live target or shooting an apple off someone's head with an arrow. I think I would...
Further investigation revealed that the camera draws 280mA at 3.7v. Even at 3.3v that would be too much for the satellite Rx port to handle...
That didn't look so bad as it could have been.... fortunately. :D
Omg! The size of that primary-drive belt! :eek::D
Greetings from Oklahoma. Yes, this forum is both informative and entertaining. It's like Facebook for "rotorheads", but without the personal...
7 1/2 minutes is still good for me. It's a 3000mAh pack. Better than 4 minutes on a 2200mAh pack
By the numbers, HS should be just over 3000. ( 3S/ 3500Kv motor, 12:150 gears )
It was a good test flight. Not noticeable power glitches. There seems to be a bit less drop in head speed during pitch bumps. Gear noise is much...
Having beefed up the wiring on the ESC and bench tested for 20 minutes running without blades, working the controls, loading the servos, I have...
Hello @ernie81 Yes, I have a clone CX450SE-V3, but it was already flybarless when I bought the kit a few months ago. It's my first build... and...
ESC mods in progress.... I replaced the thin throttle/BEC wire with two leads (one with signal wire removed) to double the connection to FBL and...
I have considered the camera as a possibility of the power failure, but it is a very small, lightweight unit designed to run on 3.3v in a 1S...
You might be right, @joeclone. I downloaded a copy of the 450L Dominator manual to get the instructions for the RCE-BL45X ESC that I'm using. I...
:D[ATTACH]
The man is not a mere mortal..... He is a Heligod! :eek:
I might consider a Pro frame, but for now, this SE frame is holding up well even after a few nasty crashes..... not to mention the fact that I...
I stopped at a nice big park late this afternoon, there was a nice overcast and no glare with a light wind. I fired up the 450 and went up to do...
Separate names with a comma.