I keep getting a strange feeling that someone around here has "multiple personality disorder"..... or I need to cut back on the caffine. :rolleyes:
Hey! Wait a minute........ (Darwin moment)....... do possums have pouches down there?? :confused:
The entire tail assy is new. I didn't think to run it up and check for vibration though. I'll go over it tonight. It might have only been...
Omg! I tried flying that 120sr in the same wind that I flew the CX450 in today... It was comical. Helium balloon is an understatement! I had to...
Wooo! That didn't work well at all! Went to the park despite some wind, threw a few pitch bumps at the 450.... good so far...... Then I pegged...
Here is a link to Walkera Online (looks like EHirobo site, same parent company) http://www.walkeraonline.com/walkera-helicopters-282995862 Here is...
Sonoffovich! It was worse than I thought. There was slack between the pots and the trim tabs.... trim tabs out of adjustment..... typical for...
What? No Drop-Bears?? :p
It's a fairly easy job. I just have to take the time to do it. ;)
Actually, that park is unoccupied more often than not. It just happened to be occupied today when I really wanted to work the 450 and see if I...
I'm about about to go into my DX4e and straighten out the gimbals. They work fine, but the manual trim tabs aren't accurately calibrated. When I...
......and as luck has it, I attempted to go to the local park a bit early after work and of course there was a pack of kids there already. I just...
No, but No but I have watched many a nature program..... general rule of thumb- That which looks deceptively harmless could very well eat your...
Haven't been able to give it a full run yet. It's a bit windy today, so I held back and stayed low. I was out to stop the near 90mm tail kick on...
I had to pull maintenance on the 120SR today. Replaced swash plate thanks to a broken ball end. The thing is freakishly easy to fly now after...
Two flights in...... Good to go. Adjusted VStabi tail settings a bit last night to correct moderate tail kick-out on hard pitch bumps- Torque...
No, I'm running back-up set. I'll order Align or Zeal blades this week.
Damage control complete.... setup complete.... Ready for flight test...... no worries. :D[ATTACH]
What sort of damage is it that you are trying to repair?
Most likely it is. Those things probably all operate on the same type of PWM output.
Separate names with a comma.
