Help What Is The Best Setup - Pitch Wise For A Goblin 700 For Hard 3d

Discussion in 'SAB' started by smakmeharder, Apr 28, 2014.

By smakmeharder on Apr 28, 2014 at 5:04 PM
  1. smakmeharder

    smakmeharder Administrator

    Ok I currently have my gobby set up at 12deg pitch and 8 degrees cyclic. It feels ok but I dont think it is quicker or nimble enough for 3d moves. It feels like I am fighting it to move the way I want.

    Setup
    The motor is a LE 4530
    The speedy is a kosmic 200
    The servos are futaba
    Blades now extinct EDGE 713
     

Comments

Discussion in 'SAB' started by smakmeharder, Apr 28, 2014.

    1. 5Fidy

      5Fidy RIP Jason

      Maybe you should try more cyclic movement say 9 or 10 del and
      say another half a degree pitch 12.5 deg
      I probably would use smaller blades say rail 696 or edge 693
      and maybe invest in a set of tareq thumbs. Lol
       
    2. Manyc

      Manyc Well-Known Member

      I've recently switched to 10 cyclic and 13 collective and it feels a lot nicer... tho this is on a trex 700 and goblin 570. Also smaller blades with a wide chord will help...

      Also what are your roll rates set to?

      Citizen#024
       
    3. Manyc

      Manyc Well-Known Member

      Also I have some edge se blades you can try.. though you break em you bought them... or me a set of rail 696's. :)

      Citizen#024
       
    4. HeliGods

      HeliGods Mark - Administrator Staff Member

      13 and 10 i reckon ...
       
    5. Radar

      Radar Moderator Staff Member

      I used to be very critical to what pitch I set now I set zero and then just set my high and low to what feels good. Last time I checked it was around 13.5deg
       
    6. Crash Heligod

      Crash Heligod Moderator Staff Member

      MORE IS GOOD! 18.. Deg not a bit less!
       
    7. Freeko

      Freeko Member

      I like 13-13.5° and 10° cyclic myself, but I really think I need to look into a set of those Tareq thumbs. :p
       

Share This Page